Műszaki könyvtár

The fault current is set to 80mA tosimulatethe high current generated at the intermittent earth fault. The zero voltage is set to 20V;theconfiguration ismade in13 states.The fault states and the first two memory states are set to 20ms. The memory states havetimesselected togetthetrip as close to set time 1,2s as possible. In generator configuration,set U4gen to aux voltage DC.Set “Advanced mode” in SVERKER configuration.

Reducing the risk of failure on high voltage instrument transformers in the transmission system using the application of narrowband dielectric frequency response (NB DFR) on HV CVTs.

This is an easy solution to measure the impedance values for cables, the values are used for calculation of compensation factor in distance protection.The compensation factor is first theoretically calculated and these values can now be compared with the measured values.

The test and maintenance of electrical components on rolling stock is not an easy job to do. Some maintainers dismount some of the parts and bring them to a central location for revision and maintenance. This is a cumbersome and time consuming exercise. In many cases, the electrical parts are replaced only when they break down and are not subject to periodical testing. This of course holds a risk as some parts, e.g. circuit breakers, are crucial for safety reasons.

The Power Grid Corporation of India Limited (PGCIL) is an Indian state-owned company headquartered in Gurugram (North India) engaged mainly in Trans-mission  of  Power  and  transmits  about  50%  of  the  total  power  generated  in  India  on  its  transmission  network.  The  company  owns  and  operates  about  1,61,790  circuit  kms  of  transmission  lines  at  800/765 kV,  400 kV,  220 kV  &  132 kV EHVAC and +500 kV HVDC levels and 248 sub-stations. Also, it has the transformation capacity of about 396 825 MVA as of 30th November 2019.

Safety warnings for DLRO2

When performing calibration verification of the TTRU3, the following factors need to be considered to achieve accurate measurements and prevent damage to your calibration fixture or TTRU3.

A BIZTONSÁGOS MUNKAVÉGZÉS KÖVETELMÉNYEI, KIF-, ÉS KÖF-KÁBELEK HIBAHELYEINEK - NAGYFESZÜLTSÉGŰ KONDENZÁTOR KISÜTÉSÉVEL TÖRTÉNŐ - BEHATÁROLÁSAKOR (angol).

The is capable of performing turns ratio tests on any phase shifting transformer by allow-ing for phase shifts to be entered with respect to the secondary winding. But with all of the differ-ent ways phase shift is expressed, how do you know if the entered phase shift value is correct?

A föld felé folyó áramot szivárgóáramnak nevezzük, amelynek értéke általában rendkívül alac sony, jellemzően kevesebb mint 1 mA. Azonban a személyeknek vagy állatoknak okozott kár vagy veszély előidézéséhez szükséges áram is alacsony, így azt az áramköri kialakítással kell biztonságos értékek közé szorítani.